Under this tab you'll find a number of detailed instructions related to PDK repairs.
Embedded Files
Shift Rod Position and Speed Sensor Replacement 997.2 and 991 (911)
Shift Rod Position and Speed Sensor Replacement 997.2 and 991 (911)
This document provides detailed instructions, including required parts and tools, for replacing either the Speed or the Distance sensors in a Porsche 997.2 or 991 versions of the 911. It shall be noted, as shown in the instructions, that it is not required to remove the transmission from the vehicle. This procedure takes about a day to perform (first time DIY'er should budget a full weekend). While there are no steps that are specifically difficult there may be some learning threshold involved in using the press/pull tools and the PIWIS. Detailed instructions on how to operate these will be added at a later date.
Distance and Speed Sensor Replacement 997 v1.pdfShift Rod Position and Speed Sensor Replacement 987.2, 981 and 718 (Cayman and Boxster)
Shift Rod Position and Speed Sensor Replacement 987.2, 981 and 718 (Cayman and Boxster)
This document provides detailed instructions, including required parts and tools, for replacing either the Speed or the Distance sensors in a Porsche 997.2 or 991 versions of the 911. It shall be noted, as shown in the instructions, that it is not required to remove the transmission from the vehicle. This procedure takes about a day to perform (first time DIY'er should budget a full weekend). While there are no steps that are specifically difficult there may be some learning threshold involved in using the press/pull tools and the PIWIS. Detailed instructions on how to operate these will be added at a later date.
Distance and Speed Sensor Replacement 987 v1.docx.pdfJUMPS PDK Distance and Speed Sensor Installation instructions
JUMPS PDK Distance and Speed Sensor Installation instructions
This document provides detailed instructions on how to install the JUMPS Speed or the Distance sensor harness. These assume the case has already been removed and do not cover actions needed after sensor installation. They do include detailed instructions on how to route the wire bundle and some of the checks that may be done before re-assembly to ensure proper function.
JUMPS Sensor Installation instructions.pdfHow to use the Rear Case Pusher / Puller Tool Kit
How to use the Rear Case Pusher / Puller Tool Kit
This document provides detailed instructions on how to use the PDK Pusher / Puller Tool Kit to press / pull the bearings installed in the rear case on / off the drive shafts. It also provides suggestions on modifications and additions to the standard tool kit to make it more versatile and easier to use.
How to perform a Shift Rod Sensor Calibration using PIWIS
How to perform a Shift Rod Sensor Calibration using PIWIS
This document provides detailed step-by-step instructions on how to use the PIWIS tool to run a calibration of the Shift Rod Sensors as well as the Clutch.
How to perform a Shift Rod Position Sensor Calibration using PIWIS.pdfPage updated
Google Sites
Report abuse